Electronics

im trying to put together a robot for nationals if i go, i am trying to do it as cheap as possible. does anyone know some GOOD cheap electronics i need suggestions for everything except motors

ok thank you

you know a good alternative for bb 12-45 other than scorpions. the bb 12-45 are sold put i cant find them ANYWHERE

thank you!!! me and joe dorfler we looking for alternative

anything smaller? like that can be used in a bots iq bot similar to the size of the bb-12-45.

do u have a few extra bb-12-45 i could buy off u

PM me. I MAY (not for sure, but maybe) have a pair of 12-45 that I won't need this year. I would offer them at a little discount from the 'new' price.

hey Alex, are all those botbitz esc reversible?

good deal

ive heard of people getting away with using the castle creations- hydra ice esc's- not sure if this is the right name but something close to this- but they said they had some luck with em

Alex P. HASD Bots wrote:

ive heard of people getting away with using the castle creations- hydra ice esc's- not sure if this is the right name but something close to this- but they said they had some luck with em

seems a tad odd to use an ESC with a built in water cooling jacket for battlebots

If you can wait a month: http://e0designs.com/products/ragebridge/

MikeNCR wrote:

If you can wait a month: http://e0designs.com/products/ragebridge/

Has there been any price set yet?

Luke wrote:

MikeNCR wrote:

If you can wait a month: http://e0designs.com/products/ragebridge/

Has there been any price set yet?

Quote :

RageBridge can be purchased in 2 configurations:

With Headers and Wires for users that want plug-and-play. The 3 R/C channel inputs and MIX pin headers are populated for you, and 6″ long 14 gauge wire pigtails are pre-soldered to the board.

Without Headers and Wires for advanced users that want maximum customization. The 3 R/C channel input header will be provided but not installed, and no wire pigtails are pre-soldered.

With is $200, Without is $180 last I'd heard.

tad to high for my purposes then

ok another question. Im looking at a new motor to use. Looking kinda in the out-runner way to reduce size in length. I am trying to design a uppercut that will possibly be used in the next 2 years i just arent really sure on any most of them require higher cell count like 6-8 any one know of a good one that will operate off of 4 possibly?